Herunterladen Inhalt Inhalt Diese Seite drucken

Scheppach Zweiräder Original Bedienungsanleitung Seite 22

Benzin-bodenhacke
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

11 Never store fuel or machine with fuel in the tank
inside a building where fumes may reach a spark,
open flame, or other sources of ignition, such as a
water heater, furnace, clothes dryer and the like. Al-
low the engine to cool before storing in any enclo-
sure.
Machine use and care
1 Never pick up or carry a machine while the en-
gine is running.
2 Do not force the machine. Use the correct ma-
chine for your application. The correct machine will
do the job better and safer at the rate for which it
was designed.
3 Do not change the engine governor settings GB
or over-speed the engine. The governor controls the
maximum safe operating speed of the engine.
4 Do not run the engine at a high speed when you
are not tilling.
5 Do not put hands or feet near rotating parts
6 Avoid contact with hot fuel, oil, exhaust fumes
and hot surfaces. Do not touch the engine or muffler.
These parts get extremely hot from operation. They
remain hot for a short time after you turn off the unit.
Allow the engine to cool before doing maintenance
or making adjustments.
7 If the machine should start to make an unusual
noise or vibration, immediately shut off the engine,
disconnect the spark plug wire, and check for the
cause. Unusual noise or vibration is generally warn-
ing of trouble.
8 Use only attachments and accessories approved
by the manufacturer. Failure to do so can result in
personal injury.
9 Maintain the machine. Check for misalignment
or binding of moving parts, breakage of parts and
any other condition that may affect the machine's
operation. If damaged, have the machine repaired
before use. Many accidents are caused by poorly
maintained equipment.
10 Keep the engine and muffler free of grass, leaves,
excessive grease or carbon build up to reduce the
chance of a fire hazard.
11 Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
12 Never douse or squirt the unit with water or any
other liquid. Keep handles dry, clean and free from
debris. Clean after each use.
13 Observe proper disposal laws and regulations for
gas, oil, etc. to protect the environment.
14 Store idle machine out of the reach of children
and do not allow persons unfamiliar with the ma-
chine or these instructions to operate it. Machine is
dangerous in the hands of untrained users.
Service
Before cleaning, repair, inspecting, or adjusting, shut
off the engine and make certain all moving parts
have stopped. Disconnect the spark plug wire, and
keep the wire away from the plug to prevent acciden-
tal starting.
Have your machine serviced by qualified repair
personnel using only identical replacement parts.
This will ensure that the safety of the machine main-
tained.
21 І 39
Specific safety rules
1 Thoroughly inspect the area to be tilled, and re-
move all debris and hard or sharp objects such as
stones, sticks, glass, wire, bones, etc.
2 Do not operate tiller in soil with large rocks and
foreign objects which can damage the machine.
3 Do not till above underground electric cables,
telephone lines, water lines, gas line, pipes, or
hoses. If in doubt, contact your utility or telephone
company to locate underground services.
4 Keep all bystanders, children, and pets at least
23m away. If you are approached, stop the unit
immediately.
5 Walk, never run with the machine.
6 This unit has a clutch. Squeeze the clutch control
lever and check that i t returns automatically to the
neutral position. If it does not, have unit adjusted
by a qualified repair personnel.
7 Disengage clutch lever before starting the engine.
8 Start the engine carefully according to instructions
and with feet well away from the tines.
9 The tines remain stationary when the clutch is
disengaged. If it does not, have unit adjusted by a
qualified repair personnel.
10 Always operate the machine from behind, never
pass or stand in front of the machine when the
engine is running.
11 Always hold the unit with both hands when oper-
ating. Keep a firm grip on the handlebars.
12 Be aware that the machine may unexpectedly
bounce upward or jump forward if the tines should
strike buried obstacles such as large stones,
roots, or stumps.
13 If the unit strikes a foreign object, stop the engine,
disconnect the spark plug, thoroughly inspect the
machine for any damage, and repair the damage
before restarting and operating the machine.
14 Use extreme caution when in reverse ornpulling
the machine towards you.
15 Do not overload the machine capacity by tilling
too deep in a single pass or at too fast a rate.
16 Never operate the tiller at high transport speeds
on hard or slippery surfaces.
17 Be careful when tilling in hard ground. The tines
may catch in the ground and propel the tiller for-
ward. If this occurs, let go of the handlebars and
do not restrain the machine.
18 Use caution when tilling near fences, buildings
and underground utilities. Rotating tines can
cause property damage or personal injury.
19 Exercise extreme caution when operating on or
crossing gravel drives, walks, or roads. Stay alert
for hidden hazards or traffic. Do not carry pas-
sengers.
20 Never leave the operating position when the
engine is running.
21 Always stop the engine when tilling is delayed or
when walking from one tilling location to another.
22 Keep unit clean of vegetation and other materi-
als. They may become lodged between the tines.
Stop the engine and disconnect the spark plug
before unclogging the tines.
Repairs
Use only the accessory and spare parts recom-
mended by the manufacturer. If the machine suers
a failure despite our quality controls and your care,
have repair work carried out only by a trained electri-
cian.

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis