Establishing The Wi-Fi Connection Via Wps; Establishing The Wifi Connection Via The Silvercrest Smart-Audio App - Silvercrest SMRS 18 A1 Bedienungsanleitung Und Sicherheitshinweise

possible to the router to achieve an optimum Wi-Fi signal transmission. Then install the speaker (A)
within the Wi-Fi signal range.
Please note that a maximum of 16 multiroom devices can be connected to a network. Furthermore
the multiroom devices and your smartphone/tablet must be connected to the same network.

Establishing the Wi-Fi connection via WPS

If your router features a WPS button, the easiest way to connect the speaker (A) to the network is
using this button.

Place the power switch (12) in "ON" position and briefly press the On/Standby button (1) to
go to connection mode. After a brief initialisation period (yellow and blue LEDs on
simultaneously, then one LED briefly lights up green) only the blue LED flashes slowly. If the
LED does not flash, the speaker must be reset: Press and hold the WPS / RESET button for
approx. 5 seconds to restart the device.

Next press the WPS button on your router and confirm the connection by pressing the WPS /
RESET button (7) on the speaker (A) back panel.
See the operating instructions for your router.
The speaker (A) establishes a network connection. The blue LED flashes 3 times fast, followed by a
short pause.

After the connection has been established, the blue LED goes on.

Now the speaker (A) can play audio signals from the network.

The speaker (A) will save the connection data, so the next time you switch it on you don't
need to re-establish the connection again.

Establishing the WiFi connection via the SilverCrest Smart-Audio App

The following contains some important instructions for setting up your device. A detailed, up-to-date
description of the SilverCrest Smart-Audio App with plenty of screenshots can be found online. You
can find the relevant internet links in the "QR codes" chapter.
Setting up a device
If you cannot establish a connection using WPS, you can use the SilverCrest Smart-Audio App to
connect your device to the network.
Power on the device and start AP mode. The AP mode lets you configure and connect your device
to the WiFi network.
SilverCrest SMRS 18 A1
English - 105