Establishing The Wi-Fi Connection Via Wps; Establishing The Wifi Connection Via The Silvercrest Smart-Audio App - Silvercrest SMRS 30 A1 Bedienungsanleitung

SilverCrest SMRS 30 A1

Establishing the Wi-Fi connection via WPS

If your router features a WPS button, the easiest way to connect the speaker (A) to the network is
using this button.

Place the power switch (8) in "ON" position and briefly press the On/Standby button (1) to
go to connection mode. After a brief initialisation period (yellow and blue LEDs on
simultaneously, then one LED briefly lights up green) only the blue LED flashes slowly. If the
LED does not flash, the speaker must be reset: Press and hold the WPS / RESET button for
approx. 5 seconds to restart the device.

Next press the WPS button on your router and confirm the connection by pressing the WPS /
RESET button (3) on the speaker (A) top.
See the operating instructions for your router.
The speaker (A) establishes a network connection. The blue LED flashes 3 times fast, followed by a
short pause.

After the connection has been established, the blue LED goes on.

Now the speaker (A) can play audio signals from the network.

The speaker (A) will save the connection data, so the next time you switch it on you don't
need to re-establish the connection again.

Establishing the WiFi connection via the SilverCrest Smart-Audio App

The following contains some important instructions for setting up your device. A detailed, up-to-date
description of the SilverCrest Smart-Audio App with plenty of screenshots can be found online. You
can find the relevant internet links in the "QR codes" chapter.
Setting up a device
If you cannot establish a connection using WPS, you can use the SilverCrest Smart-Audio App to
connect your device to the network.
Power on the device and start AP mode. The AP mode lets you configure and connect your device
to the WiFi network.
When you use it for the first time, the device starts in AP mode. Otherwise, hold the
WPS / RESET button for approx. 5 seconds to restart the device. After a brief
initialisation period (yellow and blue LEDs on simultaneously, then one LED briefly
lights up green) only the blue LED flashes slowly and the device is in AP mode.
Start the SilverCrest Smart-Audio App and select "Set up audio system". Follow the on-screen
instructions to connect the device to your WiFi network.
After setup is finished, you can add more existing WiFi devices to the network in the same way, if
you have any.
14 - English