Establishing The Wi-Fi Connection Via Wps; Establishing The Wi-Fi Connection Via The "Undok" App - Silvercrest 30 W Bedienungsanleitung

achieve an optimum Wi-Fi signal transmission. Then install the speaker (A) within the Wi-Fi signal
range.
Please note that a maximum of 16 devices can be connected to a network.

Establishing the Wi-Fi connection via WPS

If your router features a WPS button, the easiest way to connect the speaker (A) to the network is
using this button.

Place the power switch (8) in "ON" position and briefly press the On/Standby button (1) to
go to connection mode. After a brief initialisation period (yellow and blue LEDs on
simultaneously, then one LED lights green) the blue LED flashes slowly.

Next press the WPS button on your router and confirm the connection by pressing the WPS /
RESET button (3) on the speaker (A) top.
See the operating instructions for your router.
The speaker (A) establishes a network connection. The blue LED flashes 3 times fast, followed by a
short pause.

After the connection has been established, the blue LED goes on.

Now the speaker (A) can play audio signals from the network.

The speaker (A) will save the connection data, so the next time you switch it on you don't
need to re-establish the connection again.

Establishing the Wi-Fi connection via the "UNDOK" app

If you cannot establish the connection using WPS, you can use the "UNDOK" app to connect the
speaker to the network.

Power on the speaker and start the AP mode.
When using it for the first time, the speaker starts the AP mode automatically.
Otherwise hold the WPS / RESET button (3) for approx. 5 seconds to restart the
speaker. After a brief initialisation period (yellow and blue LEDs on simultaneously,
then one LED lights green) the blue LED flashes slowly and the speaker is in AP mode.

Launch the UNDOK App. Select the "Set up new audio system" option to continue.
SilverCrest SMRS 30 A1
English - 53