Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Continuous display of
measured result (HOLD)
Transmitting measured
results to wireless
receivers
Switching over
weighing range
automatically
64 •
If you activate the HOLD function, the weight value
continues to be displayed after the load has been
removed from the scale. This allows you to attend to
the baby before noting down the weight.
1. Place the load on the scale.
2. Briefly press the (hold/tare) arrow key.
hold
tare
The display flashes until a stable weight is meas-
ured. The weight value is then displayed continu-
ously. The
the message "HOLD" are displayed.
3. To disable the HOLD function, briefly press the
hold
(hold/tare) arrow key.
tare
The
longer displayed. 0.000 appears in the display. You
can perform another weighing operation if required.
NOTE
If the Autohold function is activated, the
weighed value will automatically be displayed
continuously (see section entitled "Activating
the Autohold function (Ahold)" on page 66).
If the scale is integrated in a
work, you can transmit the measured results to
receive-ready equipment (wireless printer, PC with USB
wireless adapter) at the touch of a button.
Press the (send/print) Enter key.
send
print
– Press key briefly: send measured results to all
receive-ready devices
– Hold down: print out measured result on
wireless printer
The scale has two weighing ranges. Weighing range 1
(
) provides a more precise weight indication with a
reduced load-bearing capacity. Weighing range 2 (
allows you to take advantage of the maximum load-
bearing capacity of the scale.
When the scale is switched on, weighing range 1 is
activated. If a specific weight value is exceeded, the
scale automatically switches to weighing range 2.
To switch back to weighing range 1, proceed as
follows.
symbol (non-calibratable function) and
symbol and the "HOLD" message are no
seca 360° wireless
net-
)
Werbung
Kapitel
Inhaltsverzeichnis
