5.3 Establishing power supply
Inserting and
connecting the battery
Connecting the power
pack and charging the
battery block
60 •
The scale is powered by a battery block or a power
pack (both included in scope of supply). Depending on
model, the scope of supply will include either a power
pack with plug adapters or a power pack with a fixed
Euro connector.
The battery compartment and the connecting socket
for the power pack are located on the underside of the
scale.
1. Push the battery compartment latch in the direction
of the printed word "Battery" and flip open the lid.
block
2. Remove the connecting cable from the battery
compartment.
3. Connect the plug contacts of the connecting cable
to the battery block supplied.
4. Insert the battery block in the battery compartment.
5. Close the battery compartment.
WARNING!
Personal injury and damage to device due to use
of incorrect power packs
The voltage supplied by standard power packs
may be higher than their indicated rating. This
may cause the scale to overheat, catch fire,
melt or short-circuit.
– Only use genuine seca plug-in power packs
1. Insert the power plug necessary for your power
supply in the power pack.
with a controlled 12 V output voltage.