Nice Neo Mat MHT Installierungs-Und Gebrauchsanleitungen Und Hinweise Seite 6

4.3) Optional programming
Optional programming is only possible after positions "0" and "1" have been programmed.
4.3.1) Memorisation of the intermediate position "I"
When an intermediate position "I" is memorised the awning can be manoeuvred into the "I" position by pressing the ▲ and ▼ buttons of the
transmitter together.
Follow the procedure shown in table A4 to memorise the intermediate position:
Table "A4" Programming of the intermediate position "I"
Using buttons ▲ ■ ▼ of a remote control, move the awning into the "I" position to
1.
be memorised
Press and hold down button ■ until you hear a beep (after about 5 seconds)
2.
Release and press again button ■ for another 5 seconds until 4 rapid beeps are heard
3.
Press buttons ▼ and ▲ together until 3 beeps are heard, indicating that the position
4.
has been memorised
4.3.2) Cancellation of the positions or RDC function
To modify the previously memorised positions, they must firstly be cancelled and then the new positions programmed again.
In position "1" it can be changed without cancelling it (see table "A12").
Table "A5" Cancellation of the intermediate position "I"
Press and hold down button ■ of a previously memorized transmitter until you hear a
1.
beep (after about 5 seconds)
Release and press again button ■ for another 5 seconds until 4 rapid beeps are heard
2.
Press buttons ▼ and ▲ together until 5 beeps are heard, indicating that the
3.
intermediate position has been cancelled
Table "A6" Cancellation of positions "0" and "1"
Press and hold down button ■ of a previously memorized transmitter until you hear a
1.
beep (after about 5 seconds)
Release and press again button ■ for another 5 seconds until 4 rapid beeps are heard
2.
Press button ▼ until 5 beeps signal that positions "0" and "1" have been cancelled
3.
WARNING: After positions "0" and "1" have been cancelled the awning will move with hold-to-run and a new position needs to be memo-
rised.
Note: the intermediate positions "I" and the RDC function that are programmed are not cancelled. If you wish to cancel everything (includ-
ing the codes of the transmitters), refer to table "A13".
Table "A7" Cancellation of the torque reduction function (RDC)
Press and hold down button ■ of a previously memorized transmitter until you hear a
1.
beep (after about 5 seconds)
Release and press again button ■ for another 5 seconds until 4 rapid beeps are heard
2.
Press button ■ until 5 beeps signal that RDC function has been deactivated
3.
Note: Now the awning will close at full force
5
Example
5s
5s
Example
5s
5s
Example
5s
5s
Example
5s
5s