Additional Information - Nice Neo Mat MHT Installierungs-Und Gebrauchsanleitungen Und Hinweise

6) Additional information

The Neo Mat series motors recognise the transmitters of the ERGO, PLANO, NICEWAY and VOLO S RADIO series (see chapter 6.1 "Trans-
mitters usable").
A particular command can also be associated to each transmitter button by means of a specific memorization procedure (see chapter 6.2
"Transmitter programming in Mode I and Mode II").
Warning: use transmitters that have been memorised in Mode 1 only for programming.
6.1) Available transmitters
Table A15 indicates the transmitters that can be used with the relat-
ed coding.
Table "A15"
Transmitters
ERGO1 - ERGO4 - ERGO6
PLANO1 - PLANO4 - PLANO6 - PLANO TIME
VOLO S RADIO - NEMO
NICEWAY (the whole series)
FLO1R - FLO2R - FLO4R
VERY VR
6.2) Memorizing the transmitters in Mode I and Mode II
Tables "A1" and "A2" describe the memorization of the transmitters in "Mode I" where a specific command is assigned to each button: but-
ton ▲ (1) = "Up"; button ■ (2) = "Stop"; button ▼ (3) = "Down".
It is possible to memorise the transmitters also in "Mode II"; this mode allows greater flexibility in using the keys of the transmitters. On the
same Neo Mat motor it is possible to memorise transmitters in Mode I and in Mode II.
6.2.1) Mode I
The command associated to the transmitter buttons is fixed in Mode I: button ▲
(1) = "Up"; button ■ (2) = "Stop"; button ▼ (3) = "Down", another button 4 com-
mands the "Stop".
A single memorization phase is performed in Mode I for each transmitter and a sin-
gle section is occupied in the memory. It is not important which button is pushed
when memorizing in Mode I.
Memorizing and deleting the transmitters in Mode I (see Tables A1 and A2).
6.2.2) Mode II
One of the four possible commands can be associated to each of the transmitter
buttons in Mode II: 1 = Step-by-Step; 2 = Up-Stop; 3 = Down-Stop,
4 = Stop. A memorization phase is performed for each button in Mode II, and each
occupies a section of the memory. The button pushed is memorized during mem-
orization in Mode II. A new memorization is necessary if one wishes to assign
another command to another button of the same transmitter.
9
ERGO PLANO
FLO4R VERY
Mode I
Button
Button ▲ or 1
Button ■ or 2
Button ▼ or 3
Button 4
Mode II
No. Command
1 Step-by-Step (up-stop-down-stop...),
2 Up-Stop (up-stop-up-stop...)
3 Down-Stop (down-stop-down-stop...)
4 Stop
NICEWAY VOLO S RADIO
NEMO
Command
Up
Stop
Down
Stop