MC3
NOTE
This manual apply to MC3 measuring amplifier from Hardware
Version 1.00. The label on the printed circuit board is visible when
the housing cover is opened (see (7) in the following figure).
1
Controls
The controls are accessible on opening the top of the housing.
Fig. 1.1: Control elements
Notes:
1 A screwdriver type potentiometer P 24 − setting the switching point of the
limit switch.
2 Switch S 22 − Selection of voltage or current output (option).
3 Screwdriver type potentiometer P 21 − Zero balance for amount.
4 Screwdriver type potentiometer P 22 − Zero balance for phase.
5 Screwdriver type potentiometer P 23 − Fine adjustment of meas. range.
6 Switch S 21 − Measuring range adjustment
A1705−3.2 en/de/fr
1
2
P24
S22
R58
P21
R26
P22
P23
S21
R44
5
4
6
3
7
7
HBM