Servicing, Cleaning, Maintenance; General Cleaning / Lubrication - SCHUNK KSC-F 80 Montage- Und Betriebsanleitung

_________________________________________________________________________________________
5

Servicing, cleaning, maintenance

Make sure the areas between fixed jaw and moving jaw as well as between spindle guide and
moving jaw are free from chips when you adjust the clamping range.
The parts are subject to significant loads and have been protected from contamination by
design.

5.1 General cleaning / lubrication

Regularly clean and oil contact surfaces, guides and spindle of the vice, e.g. with MOTOREX
Supergliss 68 K to ISO VG 68.
Monthly lubrication of the fine-pitch thread using a funnel-type lubricating nipple (pos. 60)
and multi-purpose grease. For this purpose, the vice must be closed so any excess grease is
displaced using the scraper. If lubrication is carried out when open, clamping may press out
the closing disc (pos. 70) of the fixed carriage (pos. 30).
Check whether or not the scraper (pos. 120) is faulty.
schunk.com XND.00030.002_B – 10/2018 31