Assembly And Adjustment - SCHUNK KSC-F 80 Montage- Und Betriebsanleitung

_________________________________________________________________________________________
7

Assembly and adjustment

 Turn the moving carriage (pos. 20) towards the spindle guide. (pos. 100)
 Secure the carriage (pos. 30) until two grooves are visible on the scraper. (pos. 120)
 Carry out alignment of the carriage and spindle assembly so that the guide surfaces match
each other and at the scraper (pos. 120) the two grooves still have to be visible. The third
groove must not be visible.
 Move the complete unit into the tool body and turn somewhat together.
 Re-insert the securing screws.
KSC-F 125 / 160: Only fit the threaded pin, because the fixed carriage must not be
clamped to the tool body. The exact position of the fixed carriage is determined by the
fixed jaw.
Check: In the maximum open position must be the two grooves visible.
schunk.com XND.00030.002_B – 10/2018 35