SCHUNK KSC-F 80 Montage- Und Betriebsanleitung Seite 34

_________________________________________________________________________________________
Changing the spindle brake O-ring
 Pull the spindle assembly slightly out of the tool body.
Section 6.1 Removal.
 Remove 2x M5 on the underside of the spindle guide. (pos. 100)
 Replace the O-ring (pos. 110) of the spindle brake.
Apply grease liberally to the O-ring and reassemble the spindle guide.
Section 7 Assembly and adjustment.
schunk.com XND.00030.002_B – 10/2018 34