Operation (Standard Operation); Clamping / Aligning - SCHUNK KSC-F 80 Montage- Und Betriebsanleitung

_________________________________________________________________________________________
4

Operation (standard operation)

4.1 Clamping / aligning

Push parts of the entire spindle unit from the tool body to attach the vice. (See on 6.1 and 7)
KSC-F 80
The following interfaces are included in the basic variant:
4 x Ø9 fixing bores for cylinder screws M8.
2 x Ø12 H7 positioning bores, in a centre distance of 100 mm.
VERO-S locating hole Ø25 H6 for mounting the clamping bolt and Ø12 H7 positioning hole
(distance 66 mm) for mounting the indexing bolt.
Longitudinal grooves on the sides to attach clamping claws.
schunk.com XND.00030.002_B – 10/2018 27