Maintenance; Emptying The Dust Container - Silvercrest SMZS 1600 A1 Bedienungs- Und Sicherheitshinweise

4 Maintenance

4.1 Emptying the dust con-
4 Maintenance
tainer
22
23
24
25
26
„
Empty the dust container when the red warning light
goes on (Fig. 22) or when the MAX mark has been reached
(Fig. 23/2).
ATTENTION:
Before emptying the dust container switch off the appli-
ance and observe the notices under ZChapter 3.3,
"Switching off and retracting power cord". In this way you
avoid dust destroying the appliance.
1. Unlatch the hose by the release catch (Fig. 23/1) and
detach the hose.
2. Remove the dust container by unlocking it (Fig. 24/1.)
and then folding it down (Fig. 24/2.).
NOTE:
Be careful when removing the dust container so that no
dust escapes.
3. Empty the dust container either
„
by opening the bottom plates (Fig. 25):
- Hold the container low over a dustbin before doing
this.
- Unlock the outer bottom plate (Fig. 25/1.).
- Then unlock the inner bottom plate (Fig. 25/2.).
or
„
by removing the cyclone unit (Fig. 26):
- Unlock the cyclone unit as shown (Fig. 26/1.).
- Detach the container from the cyclone unit (Fig. 26/
2.).
- Empty the container into a dustbin.
NOTE:
You can dispose of the contents of the dust container
with your regular domestic trash if it contains no waste
materials prohibited in domestic trash.
GB
IE
15