Refilling The Water Tank - Rommelsbacher EKS 1510 Bedienungsanleitung

Step 12:
Stop hot water supply.
Turn the rotary knob to the top.
NOTE: The appliance carries excess
water back into the water tank via a
recirculation system!

Refilling the water tank

• Avoid that the water tank is drained completely during use! We recommend checking the water level prior to each
use and refilling water up to the "MAX" marking.
• The pump generates a loud pump noise in case the water in the tank runs low.
• For refilling the water tank, there is no need to take out the water filter.
• After refilling the water tank, bleed the system if necessary.
Warning: Casing, brew head,
portafilter, filter inserts and hot
water/steam nozzle are getting hot
during use!
Step 4: (bleeding)
Position the portafilter without filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
32
• Check the water tank
regularly, refill water if
necessary.
• Check the vessel regularly,
empty it if necessary.
• This process may cause loud
pump noises.
Repeat step 11 + 12
3 times.
Step 1:
Remove the water tank
(previously remove the portafilter if
necessary).
Empty residual water.
Step 5: (bleeding)
Place a vessel below the outlet of
the hot water/steam nozzle.
Step 13:
If the appliance is not needed any
more, switch it off and pull the
mains plug.
Step 2:
Fill the water tank with fresh tap
water up to the "MAX" marking!
Step 6: (bleeding)
Choose the function
"espresso/hot water".
Step 3:
Insert the water tank.
Make sure the water tank is inserted
as far as it will go on the gasket.
Step 7: (bleeding)
Switch the appliance on.
The appliance heats up and the
temperature pilot lamp glows red
permanently.
When the lamp exinguishes, the
appliance is ready for use. The
operation pilot lamp glows blue
permanently.