Bleeding The System - Rommelsbacher EKS 1510 Bedienungsanleitung

Bleeding the system

• In order to ensure perfect operation of the appliance it is important that the system is bled prior to initial use or after
a longer non-use period.
• If the water tank gets empty during use, the system will suck air which must be removed by bleeding the system.
Warning: Casing, brew head,
portafilter, filter inserts and hot
water/steam nozzle are getting hot
during use!
Step 4:
Position the portafilter without filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
Step 8:
Start hot water supply.
Turn the rotary knob to the right.
Dispense hot water until it comes
without air. Use the water for
warming the cups.
30
Step 1:
Remove the water tank
(previously remove the portafilter if
necessary).
Step 5:
Place a vessel below the outlet of
the hot water/steam nozzle.
Step 9:
Stop hot water supply.
Turn the rotary knob to the top.
NOTE: The appliance carries excess
water back into the water tank via a
recirculation system!
Step 2:
Fill the water tank with fresh tap
water.
Observe the "MAX" marking!
Step 6:
Choose the function
"espresso/hot water".
Step 3:
Insert the water tank.
Make sure the water tank is inserted
as far as it will go on the gasket.
Step 7:
Switch the appliance on.
The appliance heats up and the
temperature pilot lamp glows red
permanently.
When the lamp exinguishes, the
appliance is ready for use. The
operation pilot lamp glows blue
permanently.