Rommelsbacher EKS 1510 Bedienungsanleitung Seite 43

Crema is not perfect?
Finding
not enough crema
crema is too dark
crema is too light
crema is not firm
First aid ...
Finding
Permanent glowing
temperature pilot lamp
(red) [1]
Quickly blinking
temperature pilot lamp
(red) [1]
Slowly glowing
operation pilot lamp
(blue) [3]
Permanent glowing
operation pilot lamp
(blue) [3]
Quickly alternate blinking
of the operation pilot lamp and
temperature pilot lamp
pump generates loud pump noise
milk froth is not satisfying
Possible cause
powder is too coarse, powder is not compressed enough, beans are too old, cup
or machine is dirty.
beans are too old, powder is too coarse, powder is not compressed enough.
beans are too old, powder is too coarse, powder is not compressed enough.
cup is too cold or too hot, water pressure is too low.
Cause and troubleshooting
No fault
Heating-up period of the thermoblock!
Thermoblock too hot after steam supply
For cooling down the system, choose the function "espresso/hot water". Turn the
rotary knob to the right. Dispense hot water for 10 seconds.
No fault
Power save mode without heating is active! To activate the appliance, press the
"on/off" switch!
No fault
Appliance is ready for use!
Wrong positon of rotary knob during switch appliance on
Switch the appliances off, position the rotaty knob to "0" and switch the
appliances on again!
Rotary switch on position "espresso/coffee" and the switch on position
"hot water/steam".
This combination is not allowed!
Water tank is empty
Refill the water tank; afterwards bleed the system by dispensing hot water!
Water tank is not inserted correctly
Insert the water tank as far as it will go on the gasket, afterwards bleed the
system by dispensing hot water!
Water filter is blocked
Remove the water filter from the tank and start dispensing water without filter. If
the supply is ok, the filter cartridge must be exchanged.
Water filter is not soaked enough
Lay the water filter in water for at least 15 minutes, afterwards insert it according
to instructions!
Blocked filter insert
Clean the filter insert thoroughly, clean sieve and holes carefully with the
cleaning pin if necessary!
milk is too warm
Use refrigerated milk!
unsuitable vessel
Use a suitable stainless steel jug!
nozzle holes are blocked
Clean the nozzle thoroughly!
43