Refilling The Water Tank - Rommelsbacher EKS 2000 Bedienungsanleitung

Step 12:
Stop hot water supply.
Turn the rotary knob to the left.

Refilling the water tank

• Avoid that the water tank is drained completely during use! We recommend checking the water level
prior to each use and refilling water up to the "MAX" marking.
• The appliance has an electronic water level control. If water is missing in the water tank, the pilot
lamp will blink in short intervals and the pump will stop.
• For refilling the water tank, there is no need to take out the water filter.
• After refilling the water tank, bleed the system if necessary.
Warning: Casing, brew head,
portafilter, filter inserts and hot
water/steam nozzle are getting hot
during use!
Step 4: (bleeding)
Position the portafilter without filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
30
• Check the water tank
regularly, refill water if
necessary.
• Check the vessel regularly,
empty it if necessary.
• This process may cause loud
pump noises.
Repeat step 11 + 12
3 times.
Step 1:
Remove the water tank
(previously remove the portafilter if
necessary).
Empty residual water.
Step 5: (bleeding)
Place a vessel below the outlet of
the hot water/steam nozzle.
Step 13:
If the appliance is not needed any
more, switch it off and pull the
mains plug.
Step 2:
Fill the water tank with fresh tap
water.
Observe the "MAX" marking!
Step 6: (bleeding)
Choose the function
"espresso/hot water".
Step 3:
Insert the water tank.
Make sure the water tank is inserted
as far as it will go on the gasket.
Step 7: (bleeding)
Switch the appliance on.
The appliance heats up and the pilot
lamp blinks. When the lamp glows
permanently, the appliance is ready
for use.