Inserting The Water Filter - Rommelsbacher EKS 1510 Bedienungsanleitung

Inserting the water filter

• Make sure the appliance had been bled correctly before inserting the water filter
(please refer to "Bleeding the system")!
• As this is an activated carbon filter, the water may take on colour when starting to rinse the filter. This is normal and
will be cleared by rinsing the filter.
• For perfect function, the filter granulate must be completely soaked. Thus, follow all below steps consecutively.
• The date of exchange can be set on the upper side of the filter (1 – 12).
• Exchange the water filter after 30 litres or after 2 months at the latest.
• Replacement filters are available in specialised trade or from our customer service.
Warning: Casing, brew head,
portafilter, filter inserts and hot
water/steam nozzle are getting hot
during use!
Step 4:
Position the filter cartridge firmly in
the intended holder at the bottom of
the water tank.
Step 8:
Place a vessel below the outlet of
the hot water/steam nozzle.
Step 1:
Unpack the filter cartridge.
Step 5:
Fill the water tank with fresh tap
water up to the "MAX" marking.
Step 9:
Choose the function
"espresso/hot water".
Step 2:
Prepare filter cartridge.
Steep the filter cartridge for 15
minutes at least in cold tap water.
Step 6:
Insert the water tank.
Make sure the water tank is inserted
as far as it will go on the gasket.
Step 10:
Switch the appliance on.
The appliance heats up and the
temperature pilot lamp glows red
permanently.
When the lamp exinguishes, the
appliance is ready for use. The
operation pilot lamp glows blue
permanently.
Step 3:
Remove the water tank
(previously remove the portafilter if
necessary).
Empty residual water.
Step 7:
Position the portafilter without filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
Step 11:
Start hot water supply.
Turn the rotary knob to the right.
Dispense hot water for 1 minute. Use
the water for warming the cups.
31