Power Save Mode; Frothing Milk - Rommelsbacher EKS 1510 Bedienungsanleitung

Power save mode:

After 10 min. without operation,
the appliance switches to power
save mode, without heating of the
thermoblock. The operation pilot
lamp blinks slowly (every 2 sec.).
By actuating the switch ON/OFF, the
appliance can be activated again.
After a short heating-up phase, the
appliance is ready for use.

Frothing milk

• For having perfect results, we recommend ...
... using refrigerated milk only
... using a stainless steel jug.
• Dip the hot water/steam nozzle in the milk and start frothing in the upper third of the milk. Hold the jug a little slant
and slightly move it up and down. The nozzle must remain under the milk surface as otherwise the milk froth will be
too large-pored. (After a few trials and with a little practice, you will quickly find the correct method).
• Attention: Make sure that the holes in the nozzle are always clean and not clogged.
• Attention: For moving the nozzle, only touch it at the upper plastic part.
• Attention: After frothing, the system must be cooled manually (see steps 12 – 15).
Warning: Casing, brew head,
portafilter, filter inserts and hot
water/steam nozzle are getting hot
during use!
Step 14:
If the appliance is not needed any
more, switch it off and pull the
mains plug.
• Check the water tank
regularly, refill water if
necessary.
• Check the drip pan
regularly, empty it if
necessary.
Step 1:
Prepare the appliance.
Nähere Informationen
hierzu finden Sie unter
„Reinigung und Pflege".
Step 15:
Clean the appliance and the
accessories.
Step 2:
Position the portafilter without filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
Step 3:
Place a vessel below the outlet of
the hot water/steam nozzle.
35