Rommelsbacher EKS 1510 Bedienungsanleitung Seite 41

Step 17:
Stop the descaling process.
Turn the rotary knob to the top.
NOTE: The appliance carries excess
water back into the water tank via a
recirculation system!
Step 21:
Remove the water tank.
Step 25:
Position the portafilter without filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
Step 18:
Switch the appliance off.
Step 22:
Empty the water tank and clean it
thoroughly.
Step 26:
Place a vessel below the outlet of
the portafilter.
Step 19:
Remove the vessel.
Step 23:
Fill the water tank with fresh tap
water up to the "MAX" marking!
Step 27:
Choose the function
"espresso/hot water".
Step 20:
Remove the portafilter.
Attention, the portafilter drips
slightly.
Step 24:
Insert the water tank.
Make sure the water tank is inserted
as far as it will go on the gasket.
Step 28:
Switch the appliance on.
The appliance heats up and the
temperature pilot lamp glows red
permanently.
When the lamp exinguishes, the
appliance is ready for use. The
operation pilot lamp glows blue
permanently.
41