Control Techniques Commander SE Betriebsanleitung Seite 70

• Press the
3. If the drive trips during these tests the display will show, for example
tr
The right hand display will flash with the trip code
4. Press the
the drive.
5. The
On.
If this test has been carried out as a bench test and the drive is to be connected to
NOTE
a different motor with different characteristics etc. in the application, then the
motor map parameters should be set to the correct values for the new motor and
another autotune carried out (see parameter 38 for details).
70
STOP key to STOP the drive. The display should show:
0.0
rd
OU
RESET button to reset the trip. Press the
FORWARD/REVERSE button can be enabled by setting parameter 26 =
www.controltechniques.com
RUN button to run
Commander SE User Guide
Issue Number 9