Extreme Operating And Fault Conditions; Specification - STIEBEL ELTRON DHB-E 13 SLI electronic Bedienung Und Installation

installation

spEcification

13.5

extreme operating and fault conditions

Operating temperatures can reach up to 60 °C. In case of faults, loads up to max. 95 °C at a pressure of 1.2 MPa can occur temporarily
in the installation.
13.6 Specification
model
Type
Part no.
operating details
Rated output
Rated current
Fuse protection
Selectable output
Power connection
Nominal capacity
Type
Rated operating pressure
Temperature setting range
Pressure drop with flow limiter
Pressure drop without flow
limiter
Flow limiter
Cold water inlet temperature
Test symbols
Approvals/certifications
Protection class to EN 60335
Protection level to EN 60529
Bare wire heating system
Applications
Flow rate "ON"
dimensions and weights
Dimensions H x W x D
Weight
Water connection
* Pressure drop values also apply to minimum flow pressure to DIN 44851/ flow rate for heating from 10 °C to 60 °C (∆ϕ 50 K). With
reference to DIN 1988 part 3, table 4, a pressure drop of 0.1 MPa is recommended for sizing the pipework.
36 |dhB-e ... sil electronic
electronically controlled instantaneous water heater
DHB-E 11 SLi
electronic
227485
11
A 16
A 16
no
3/PE ~ 400 V - 50 Hz
l 0.4
sealed unvented
MPa 1
°C ~ 30 - 60
MPa / l/min 0.07 / 3.1
MPa / l/min 0.02 / 3.1
l/min 4.0
colour pink
°C ≤ 25
see type plate
see chapter "Locally applicable approvals/certifications"
1
IP 25, hoseproof (IP 24 power supply for finished walls)
900 Ωcm (see chapter "Application range")
water with low limescale levels and those with limescale content
l/min ≥ 3.0
mm 478 x 225 x 114
kg ~ 3.6
G ½" (male thread))
DHB-E 18 SLi 25 A DHB-E 18/21/24 SLi
electronic electronic
227486 227487
18 18
26 29
25 32
no yes
0.08 / 5.2 0.08 / 5.2
0.06 / 5.2 0.06 / 5.2
7.5 7.5
blue blue
DHB-E 27 SLi
electronic
227488
21 24 27
31 35 39
32 35 40
yes yes no
0.10 / 6.0 0.13 / 6.9 0.16 / 7.7
0.08 / 6.0 0.10 / 6.9 0.12 / 7.7
7.5 8.5 8.5
blue green green
www.stiebel-eltron.com