Installation In Case Of Appliance Replacement - STIEBEL ELTRON DHB-E 13 SLI electronic Bedienung Und Installation

installation
installation
»
Push the union nuts over the connection pipes.
»
Solder the inserts to the copper pipes.
»
Push the lower part of the back panel under the connection pipes
and click it into place in the back panel.
»
Secure the connection pipes to the appliance.
Valve installation information.
Observe the valve manufacturer's installation
instructions.
9.5.7 Water installation for finished walls, fitting the
appliance cap
The following steps are necessary to complete the appliance cap
installation.
»
Cleanly break out the knock-out in the appliance cap. If necessary,
use a file.
»
Break the tabs out of the cap guides.
Installation information if tap pipes are slightly
offset.
The appliance can be sealed by fitting the cap guides
with tabs if the tap pipes are slightly offset. The back
panel guides are not required in this case.
»
Click the cap guides provided into place in the knock-outs.
»
Position the back panel guides on the pipes and push them
together. Then push the guides until they meet the back panel.
»
Secure the back panel at the bottom with a screw. This
is also relevant if flexible water supply systems are used.
www.stiebel-eltron.com
Installation information for taps for finished walls
1
2
3
4
1 Knock-out
2 Cap guides
3 Back panel guides
4 Screw
9.5.8 Split lower part of back panel
With threaded connections for finished walls, the lower part of the
back panel can also be installed after fitting the taps:
»
Saw out the centre section of the lower part of the back panel.
»
Insert the pipes from the separate pack from behind into the
centre section.
»
Route the centre section under the pipes and push it upwards.
»
Fasten the lower part of the back panel to the centre section.
»
Click the lower part of the back panel into place in the back panel.
The lower part must be secured with an additional screw.
»
Secure the connecting pipes of the valve to the appliance.
Installation with split lower part
9.5.9

Installation in case of appliance replacement

An existing mounting bracket can be used when replacing
Stiebel Eltron appliances (except "DHF"). For this, open a suitable
knock-out in the back panel for the stud of the existing mounting
bracket.
If the appliance is being installed in place of a DHF, move the
stud on the mounting bracket as shown in the diagram "Mounting
bracket for DHF appliance replacement". The stud cuts its own
groove. Then turn the mounting bracket through 180° to be
mounted on the wall. The logo "DHF" is then turned towards the
reader.
If replacing a third party appliance, suitable holes for rawl plugs
can be used.
dhB-e ... sli electronic | 31