Installation Versions - STIEBEL ELTRON DHB-E 13 SLI electronic Bedienung Und Installation

installation
installation
Earth connection
Ensure that the appliance is connected to earth.
Power connection
9.4.12 Fitting the lower back panel
Installing and securing lower part of back panel
9.4.13 Completing the installation process
»
Align the mounted appliance by loosening the fixing toggle,
aligning the power supply and back panel, and then retightening
the fixing toggle. If the back panel of the appliance is not flush
against the wall, the appliance can be fixed with a screw in the
lower part.
www.stiebel-eltron.com
9.5

Installation versions

9.5.1 Power supply from above for unfinished walls
The following diagram shows the dimensions for the power supply
from above.
Dimensions for power connection from above for finished walls (AP)
To connect the power supply, take the following steps:
»
Open out the cable grommet to match the cross-section of the
power cable.
»
Push down and remove the locking hook that secures the mains
terminal.
»
Move the mains terminal in the appliance from the bottom to
the top and click into place.
Power supply from above
9.5.2 Power supply for finished walls
The appliance can also be connected if the power supply has been
routed over finished walls. This applies to the connection from
below and above. Take the following steps:
»
Cut or break knock-outs in the back panel and appliance
cap. Possible knock-out points can be seen in the diagram
"Dimensions for power supply".
dhB-e ... sli electronic | 29