Connecting The Power Supply - STIEBEL ELTRON DHB-E 13 SLI electronic Bedienung Und Installation

installation
installation
from behind into the back panel, to reduce the stiffness or the
grommet.
»
Remove the fixing toggle from the upper part of the back panel
(diagram "Mounting the appliance").
»
Route the power cable from behind through the cable grommet
until it rests against the cable sheath. Align the power cable.
If the cross-section of the power cable is greater than 6 mm,
enlarge the hole in the cable grommet (see also "Power supply
for larger cross-sections").
»
Push the appliance over the stud of the mounting bracket, so
that it breaks through the soft seal. If necessary pierce the soft
seal with a screwdriver.
»
Put the fixing toggle onto the stud of the mounting bracket that
penetrates the back panel.
»
Press the back panel firmly into place and lock the fixing toggle
by turning it through 90°.
28 |dhB-e ... sil electronic
Mounting the appliance
9.4.10 Finalising the water connection
Water connection
9.4.11

Connecting the power supply

»
Connect the power cable to the mains terminal (see chapter
"Wiring diagram").
www.stiebel-eltron.com