Installation Instructions - Kathrein UFO compact Bedienungsanleitung

Features
Basic unit with 12 insert positions
Suitable for wall mounting (if necessary additional
front cover UFZ 412/D and amplifi er kit UFZ 412/V
available) and for fi tting in 19" racks (such as
Kathrein TUG 100)
Completely pre-assembled, with power supply unit,
fans, output coupler, input splitter and cabling
Reliable heat dissipation thanks to two fans,
therefore suitable for use in non-air-conditioned
rooms and where the contents of 19" racks are
tightly packed
Prepared for mounting the data bus
de-multiplexer UFX 314
Galvanised sheet steel module rack
Installation height: 9 HU
For indoor installation
Dimensions (mm): 483 x 408 x 350 (19" installation depth: 265)
Packing unit/weight (pc./kg): 1/12.5
Accessories
(not included)
UFG 300 20610082
UFZ 412/D 20610098
UFZ 412/V 20610099

Installation instructions

The base unit UFG 412 is suitable both for installation in 19" racks and also for wall mounting.
Wall mounting
19" rack installation
®
UFO compact signal processing system
Base unit
Controller
Front cover
Amplifi er kit
If there is no requirement for an enclosed base unit, these can be mounted directly on the wall
using only three screws (min. Ø: 6-8 mm) (weight full: approx. 25 kg).
The following articles can be purchased separately:
- UFZ 412/D: Front cover for closing the base unit
- UFZ 412/V: Amplifi er kit (amplifi er and remote feed diplexer with connection cables)
In air-conditioned rooms with a maximum ambient temperature of 40 °C, up to four base units
can be stacked one above the other.
A minimum of one height unit (1HU) clearance should be left between each of the units
Note: For insertion in 19" racks, the two side pieces and the earth clip must be removed.
Note:
The amplifi er kit UFZ 412/V shown is not
included with the UFG 412 (see accessories).
UFX 314 20610071
USW 30 20610041
UFG 412
20610090
Data bus de-multiplexer
Software