Acoustic Signals; Before First Use - Electrolux GA45GLV220 Benutzerinformation

Activating the multitab function
Activate or deactivate the multitab
function before the start of a pro-
gramme. You cannot activate or
deactivate this function while a
programme operates.
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode. Refer to 'SET-
TING AND STARTING A PRO-
GRAMME'.
2. Press the multitab button, the multitab
indicator comes on.
The function stays on until you de-
activate it. Press the multitab but-
ton, the multitab indicator goes
off.
If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Deactivate the multitab function.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse
aid.

6. BEFORE FIRST USE

1. Make sure that the set level of the wa-
ter softener agrees with the water
hardness in your area. If not, adjust
the water softener. Contact your local
water authority to know the water
hardness in your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.

5.3 Acoustic signals

The acoustic signals operate in these
conditions:
• The programme is completed.
• The level of the water softener is adjus-
ted electronically.
• The appliance has a malfunction.
Factory setting: on. You can de-
activate the acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode. Refer to 'SET-
TING AND STARTING A PRO-
GRAMME'.
2. Press and hold buttons (4) and (5) at
the same time until the indicators of
buttons (3), (4) and (5) flash.
3. Press button (5),
• The indicators of buttons (3) and (4)
go off.
• The indicator of button (5) continues
to flash.
• The display shows the setting of the
acoustic signals.
4. Press button (5) to change the setting.
5. Deactivate the appliance to confirm.
5. Processing residues can stay in the
appliance. Start a programme to re-
move them. Do not use detergent and
do not load the baskets.
If you use the combi detergent
tablets, activate the multitab op-
tion.
ENGLISH 57
On
Off