Setting And Starting A Programme; Setting Mode - Electrolux GA45GLV220 Benutzerinformation

60 www.electrolux.com
7.1 Using the detergent
A
7.2 Setting and starting a
programme

Setting mode

The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when,
after the activation the display shows 2
horizontal status bars.
If the control panel shows other condi-
tions, press the cancel button until the ap-
pliance is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode.
3. Set the programme.
• The related programme number
flashes in the display.
4. If you want, you can set the options.
5. Close the appliance door. The pro-
gramme starts.
• If you open the door, the display
shows the programme duration that
decreases with steps of 1 minute.
Starting a programme with delay
start
1. Set the programme.
2. Press the delay button again and
again until the display shows the delay
B
30 A
20
+ -
C
1.
Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5.
Close the lid. Make sure that the re-
lease button locks into position.
time you want to set (from 1 to 24
hours).
• The delay time flashes in the dis-
play.
• The delay indicator is on.
3. Close the appliance door. The count-
down starts.
• If you open the door, the display
shows the countdown of the delay
start that decreases with steps of 1
hour.
When the countdown is completed, the
programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while
the countdown operates
Press the cancel button until the display
shows 2 horizontal status bars.
When you cancel a delay start, the
appliance goes back to setting
mode. You have to set the pro-
gramme again.
Cancelling the programme
Press the cancel button until the display
shows 2 horizontal status bars.
Make sure that there is detergent
in the detergent dispenser before
you start a new programme.