Electrical Safety - Ferm BGM1021 Bersetzung Der Originalbetriebsanleitung

Keep bystanders away
Wear ear and eye protection
Special safety instructions
When using the machine for the first time
• N ever use the tool without the PRCD delivered
with the tool.
• K eep water clear off the electrical parts of the
tool and away from persons in the working area.
• I f the mains cable has been damaged, it must
be replaced with a special mains cable. These
can be obtained from the manufacturer or the
manufacturer's customer service department.
The mains cable may only be replaced by the
manufacturer, the manufacturer's customer
service department or equally qualified persons.
• C heck the following:
• D oes the voltage rating of the bench grinder
correspond to the power supply?
• I s an earthed mains power socket available?
• A re the power cord and plug in good condition
(solid, without fraying or other damage)?
• A void the use of long extension cords. The
extension cords you use must always be
earthed.
• A grinding wheel is a brittle toolpiece. The
stone is not resistant to knocks.
Always grind on the front edge of the grinding
wheel, and never on the side of the grinding
wheel. Never fit a cracked grinding wheel.
Replace it immediately, as the high rotational
speed could cause the stone to fly apart,
causing a serious accident.
• A lways wear safety glasses when grinding.
• N ever grind without the cover fitted over the
grinding wheel.
• A lways fit the grinding wheel cover and tool
rest tightly, and with the correct clearance.
• N ever allow more than 1-1.5 mm clearance
between tool rest and grinding wheel.
• O nly use the grinding wheel for the work it was
designed for (for example sharpening tools),
and NOT for heavy construction work.
The following information must be available,
before you fit any new grinding wheel:
4
All manuals and user guides at all-guides.com
• D etails about the manufacturer.
• B inding material.
• D imensions.
• P ermissible rotational speed.
• N ever ream out the hole in a grinding wheel to
• T he maximum rotational speed of the grinding
• N ever use any grinding wheel that is damaged
• I n order to be able to grind safely, the machine
• T he tool rest should be replaced whenever the
• T he recommended depth of the recess in the
Whenever using the machine
• C heck that the switch is NOT in the 'ON/1'
• A lways keep the power cord out of the way of
Immediately switch off the machine whenever:
• T he plug or power cord is defective or damaged.
• T he switch is defective.
• Y ou smell smoke or burning insulation.

Electrical safety

When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
a larger diameter.
wheel should never be allowed to exceed the
maximum speed given for the wheel.
or deformed.
must be firmly bolted to a workbench.
width of the tool rest measures less than 20 mm.
flange (T) is 2 mm and the diameter of the
spindle hole is 13 mm (see Fig. D).
position before connecting the machine to the
power supply.
the tool's moving parts.
Always check that the power supply
corresponds to the voltage on the rating
plate.