Mode Ii - Nice Patio Control Installations- Und Bedienungsanleitung

Pairing one additional transmitter equipped with a [PRG]
button:
on the transmitter already memorised: press button
1.
[PRG] for 5 seconds; LED "L1" (red) will flash twice, then it
will pause for 3 seconds and flash twice again
2. on the transmitter to be memorised: press button [PRG]
for 5 seconds; LED "L1" (red) will flash 2 times
on the transmitter already memorised: press and re-
3.
lease button [PRG] once only; LED "L1" (red) will flash 3
times.
Pairing one additional transmitter NOT equipped with a
[PRG] button:
1. on the transmitter to be memorised: press the button for
10 seconds [STOP
o
on the transmitter already memorised press and re-
2.
lease the button three times [STOP
3. on the transmitter to be memorised: press and release
button [STOP
] once only; LED "L1" (red) will flash twice.
o
12 – ENGLISH
]
]
o

5.1.2 Mode II

9
Selector [S1]: remote unit (1 = ON); LED unit (2 = OFF).
Programming with transmitters equipped with [PRG] and
[ESC] buttons:
1. on the transmitter already memorised in "Mode I":
press button [PRG] for 5 seconds; LED "L1" (red) will flash
twice, then it will pause for 3 seconds and flash twice
again
on the transmitter to be memorised: press button [PRG]
2.
for 5 seconds; LED "L1" (red) will flash 2 times
3. on the transmitter already memorised in "Mode I", se-
lect the desired option from the "Table 1" and program
as follows: press and release the button [STOP
number of times indicated in the chosen option; LED "L1"
(red) will flash the same number of times as the number of
impulses entered
on the transmitter to be memorised: press the memo-
4.
rise button for 5 seconds; LED "L1" (red) will flash 3 times.
L2
S1
L1
] the
o