Program Changes - Korg HT-70 Bedienungsanleitung

Program changes

These messages can be sent by the HT-70 to select program numbers on
an external MIDI device, or received from a connected MIDI device to
switch program numbers on the HT-70.
Transmitting program changes
Program numbers on a connected external MIDI device can be switched
from the HT-70.
• When you change the setting of the sound selector, the HT-70 will
send out the corresponding program change number. The correspon-
dences are shown in the table in the next section.
Receiving program changes
When the HT-70 receives a program change number from an external
device, its multi-timbral sound generator will change programs as
shown in the table below.
Note, however, that the selected MIDI channel (☞p.20) ignores program
changes.
The HT-70 will change sounds (timbres) in accordance with received
program change numbers indicated in the table below. If the remote
MIDI devices send the HT-70 a program change number not included in
the list below, the HT-70 will stop generating MIDI sound.
Single Bank# PC#
00 00
01 00
00 04
00 05
00 06
00 19
00 16
00 48
Program Change Filter
Set the filter ON if you wish to disable sending and receiving of program
change information. Set the filter OFF if you wish to enable transmission
of this information.
Filtering resets to OFF for all MIDI channels when the power is
turned on.
1. Hold down [FUNC.] for about one second.
The switch's LED begins flashing.
2. Press [DISPLAY] several times, until "PC" appears on the multidis-
play.
When you release the switch, the multidisplay shows the current set-
ting. (The factory setting is oFF).
3. Press [▲] or [▼] as necessary to change the setting.
Display on
Program change filter on
4. Press [FUNC.] to complete the setting.
The setting is stored and the [FUNC.] LED goes dark.
Sound
PIANO1
PIANO2
E.PIANO1
E.PIANO2
HARPSI.
P.ORGAN
E.ORGAN
STRINGS
oFF
off
Control Change Filter
Control change messages send information that is used to set the opera-
tion of controllers such as the damper pedal. External MIDI devices use
these messages to control the operation on the HT-70, and the HT-70
uses them to control the operation on external MIDI devices.
Set the filter OFF if you wish to enable sending and receiving of control
change messages. Set the filter ON if you wish to disable transmission of
this information.
Filtering resets to OFF for all MIDI channels when the power is
turned on.
1. Hold down [REVERB] for about one second.
The switch's LED begins flashing.
2. Press [DISPLAY] several times, until "CC" appears on the multidis-
play.
When you release the switch, the multidisplay shows the current set-
ting. (The factory setting is oFF).
3. Press [▲] or [▼] as necessary to change the setting.
Display on
Contorl change filter on
4. Press [FUNC.] to complete the setting.
The setting is stored and the [FUNC.] LED goes dark.
oFF
off
21