Adjusting The Gray Balance - Sony UP-D70A Bedienungsanleitung

Adjusting the Gray Balance

The ink ribbon and the paper are contained in one same package as a pair. The gray
balance may differ depending on each pair. It is recommended that you adjust the
gray balance each time you reload the ink ribbon and paper.
The gray balance was set to No.0 at the factory. The setting of the gray balance
remains effective until reset - even if you turn the power off.
Before adjusting the gray balance
Perform the following:
• Set the adjusted values for printouts, except SHARPNESS and LAMINATION,
to zero (0). (See page 23.)
If the printout adjustment was performed at the computer site, then also set them
to 0.
• Set the gray balance to pattern No.0, if you adjusted the gray balance previously.
(See explanation described below.)
1
2
3
4
5
6
Open the GrayADJ 1 file in the Image folder on the supplied CD-ROM and
make a printout of the gray adjustment patterns from No.0 to No.36.
Select the printout pattern No. which had the best gray adjustment among the
patterns printed.
If you cannot find a proper one, open the GrayADJ 2 file in the Image folder
and make a printout of the gray adjustment patterns from No.37 to No.72.
Select the printout pattern No. which had the best gray adjustment among the
patterns printed.
Press the MENU button.
Display the GRAY ADJUST menu by pressing the ◊ or √ button.
GRA Y AD J US T
N o . = 0
5, 8 6, 7
(Continued)
25
Operation