Connecting The Ac Power Cord - Sony UP-D70A Bedienungsanleitung

Connections (Continued)

Connecting the AC Power Cord

12
Preparation
SCSI ID Setting
The SCSI ID selection must be different from any other device on the bus. If two
SCSI devices have the same ID, a malfunction will occur.
SCSI ID SCSI ID Switch
4
0
0
a)
1
0
2
0
3
0
4
4
5
4
6 4
7
4
a) The SCSI ID has been set to 1 at the factory.
Connect the supplied AC power cord to the AC IN connector on the rear of the
printer and then connect the cord to the wall outlet.
To AC IN
Printer
Note
Operate the printer only on 220 to 240 V AC 50/60 Hz.
2
0
0
2
2
0
0
2
2
AC power cord
(supplied)
To wall outlet
1
0
1
0
1
0
1
0
1