Dcc-Protocol - Märklin 60985 Handbuch

DCC Protocol
Addresses
• Short address – long address – multiple unit address
• Address range:
1 - 127 for short address and multiple unit address,
1 - 10239 for long address
• Every address can be programmed manually.
• A short or a long address is selected using the CVs.
• A multiple unit address that is being used deactivates the
standard address.
Programming
• The characteristics can be changed repeatedly using the
Configuration Variables (CV).
• The CV numbers and the CV values are entered directly.
• The CVs can be read and programmed repeatedly. (Program-
ming is done on the programming track.)
• The CVs can be programmed in any order desired. (Program-
ming can be done on the main track PoM). The PoM can only
be done with those designated in the CV table. Programming
on the main track PoM must be supported by your central
controller (Please see the description for this unit.).
• The default settings (factory settings) can be produced re-
peatedly.
• 14/28 or 126 speed levels can be set.
• All of the functions can be controlled according to the func-
tion mapping (see CV description).
• See the CV description for the DCC protocol for additional
information.
32
We recommend that in general programming should be done on
the programming track.