Putting Into Operation - Abicor Binzel BRS-LCi SPS Betriebsanleitung

6 Putting into operation

6 Putting into operation
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly,
disassembly, and repair work:
• Switch off the power source.
• Close the compressed-air supply.
• Disconnect the power supply.
NOTICE
• Please take note of the following instructions:
 2 Safety on page EN-5
• The system may only be installed and put into operation by qualified personnel (in Germany, see
• Make sure that the cleaning process is not impaired by the collecting tray and the bottle holder.
7
6
5
4
1 Position 1
2 Clamping position P2
3 Position 3
Fig. 7 Putting into operation
EN - 14
DANGER
TRBS 1203).
1 2
4 Motor clamp
5 Lowest position (stroke down)
BRS-LCi PLC
3
6 Distance sleeve
7 Gas nozzle