Putting Out Of Operation; Maintenance And Cleaning - Abicor Binzel BRS-LCi SPS Betriebsanleitung

BRS-LCi PLC

8 Putting out of operation

NOTICE
• As the BRS-LCi PLC torch cleaning station is integrated into a welding system, the process for putting
1 Switch off the robot control.

9 Maintenance and cleaning

Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free operation.
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly,
disassembly, and repair work:
• Switch off the power source.
• Close the compressed-air supply.
• Disconnect the power supply.
• Switch off the entire welding system.
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed, or worn parts.
NOTICE
• Maintenance and cleaning work may only be carried out by qualified personnel (in Germany, see
• Always wear your personal protective equipment when performing maintenance and cleaning work.
it out of operation depends on the robot control system. Please make sure that the shutdown
procedures for all components integrated in the welding system are strictly observed.
DANGER
DANGER
TRBS 1203).
8 Putting out of operation
EN - 23