Maintenance And Cleaning - Abicor Binzel BRS-LC Betriebsanleitung

7 Operation
7 Operation
NOTICE
• The BRS-LC may only be operated by qualified personnel (in Germany see TRBS 1203).
• As the BRS-LC cleaning station is integrated into a welding system, the operating instructions of the
• Make sure that the BRS-LC is operated with the delivered protective device only.
1 Switch on the robot control.
2 Start the welding process.
3 Stop the welding process.
8 Putting out of operation
NOTICE
• As the BRS-LC is integrated into a welding system, putting out of operation depends on the robot
1 Switch off the robot control.

9 Maintenance and cleaning

Regular maintenance and cleaning is a prerequisite for a long life and a trouble-free operation.
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Disconnect the mains plug.
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
NOTICE
• Maintenance and cleaning work may only be carried out by qualified personnel
• Always wear your personal protective clothing when performing maintenance and cleaning work.
EN - 18
welding components, such as welding torch and robot control system, must be observed during
operation.
control system. Please make sure that the shutdown procedures for all components integrated in the
welding system are strictly observed.
DANGER
DANGER
(in Germany see TRBS 1203).
BRS-LC