Description Of Appliance; Technical Specifications - clage MBH3 Gebrauchs- Und Montageanleitung

Description of appliance

2. Description of appliance
This instantaneous water heater is intended to provide the economical heating of water suf-
ficient for a single outlet, i.e. handwash basin, and is installed together with a sanitary water
fitting.
When the hot water tap is opened, the instantaneous water heater switches itself on auto-
matically and heats the water as it passes through the appliance. It is only then that the appli-
ance uses electricity. The temperature increase depends on the flow rate.

2.1 Technical specifications

Type
Energy efficiency class
Capacity
Max. operating pressure
Heating system
Min. water resistance at 15 °C
Max. water inlet temperature
Rated voltage
Rated power
Rated current
Required min. cable cross-section
Hot water output at ∆t = 25 K
Switching on at
Switching off at
Approx. weight when filled with water
Protection class
Marking / Approvals
*) The declaration complies with the EU regulation No 812/2013. The product data sheet is attached at the end of this document.
1) The specific resistance can be asked for at your water distribution company.
2) Temperature increase from e. g. 15 °C to 40 °C.
MBH 3
Litre
MPa (bar)
Ωcm
1)
°C
kW
A
mm
2
2) l/min
l/min
l/min
kg
MBH 4
IES® bare wire heating system
1~ / N / PE 230 V AC
3.5 4.4
15.2 19.1
1.5 2.5
2.0 2.5
1.3 1.8
1.0 1.4
see rating plate
21
MBH 6 MBH 7
A *)
0.2
1 (10)
1100
20
2~ / PE 400 V AC
5.7
24.8
4.0
3.3
2.2
1.7
1.5
IP 25
EN
6.5
16.3
1.5
3.7
2.4
2.0