At The End Of The Programme - Electrolux WASL2E 200 Benutzerinformation

44 electrolux
If a delayed start is set, the appliance starts
the countdown.
The appliance adjust automatically the cy-
cle time to the laundry you have put in the
drum to have perfect washing results in
the minimum necessary time. After ap-
proximately 15 minutes from the start of
the programme, the display shows the
new time value.
INTERRUPT A PROGRAMME
1. Press button
4
2. Press button
4
programme continues.
CANCEL A PROGRAMME
1. Press button
1
gramme and to deactivate the appli-
ance.
2. Press button
1
appliance. Now, you can set a new
washing programme.
The appliance does not drain the wa-
ter.
CHANGE A FUNCTION
You can change only some functions be-
fore they operate.

AT THE END OF THE PROGRAMME

• The appliance stops automatically.
• The acoustic signals operate.
• In the display
• The indicator of the Start/Pause button
4
goes off.
• The door lock symbol goes off.
• Press button
1
ance. After five minutes from the end of
the programme, the energy saving func-
tion automatically deactivates the appli-
ance.
When you activate the appliance again,
the display show the end of the last set
programme. Turn the programme knob
to set a new cycle.
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Keep the door ajar, to prevent mildew
and odours.
. The indicator flashes.
again. The washing
to cancel the pro-
again to activate the
comes on.
to deactivate the appli-
1. Press button
4
2. Change the function set.
OPEN THE DOOR
While a programme or the delay start oper-
ates, the appliance door is locked.
To open the appliance door:
1. Press button
4
bol in the display goes off.
2. Open the appliance door.
3. Close the appliance door and press
button 4 . The programme or the de-
lay start continues.
If the temperature and level of the wa-
ter in the drum are too high, the door
lock symbol stays on and you cannot
open the door. To open the door do
the steps that follow:
1. Deactivate the appliance.
2. Wait for some minutes.
3. Make sure that no water is in the
drum.
Important! If you deactivate the appliance,
it is necessary to set the programme again.
• Close the water tap.
The washing programme is completed,
but there is water in the drum:
– The drum turns regularly to prevent the
creases in the laundry.
– The door stays locked.
– You must drain the water to open the
door.
To drain the water:
1. If necessary, decrease the spin speed.
2. Press the Start/Pause button
appliance drain the water and spin.
3. When the programme is completed
and the door lock symbol goes off, you
can open the door
4. Deactivate the appliance.
The appliance drain and spin automati-
cally after approximately 18 hours.
. The indicator flashes.
. The door lock sym-
4 . The