Setting The Delay Start; Starting A Programme - Electrolux WASL2E 200 Benutzerinformation

Check the position of the flap
1. Pull out the detergent dispenser until it
stops.
2. Press the lever down to remove the
dispenser.
3. To use powder detergent, turn the flap
up.

SETTING THE DELAY START

SET THE DELAY START
1. Press button
5
the display shows the number of mi-
nutes or hours. The related symbols
comes on.
2. Press button
4
the countdown of the delay start.
When the countdown is completed, the
programme starts automatically.
Before you press button
appliance, you can cancel or change
the set of the delay start.

STARTING A PROGRAMME

• Press button
4
The related indicator flashes no more.
again and again until
, the appliance starts
4 to start the
to start the programme.
4. To use liquid detergent, turn the flap
down.
5. Measure out the detergent and the fab-
ric conditioner.
6. Carefully close the detergent dispenser.
Make sure that the flap does not cause
a blockage when you close the drawer.
With the flap in the position DOWN:
– Do not use gelatinous or thick liquid
detergents.
– Do not put more liquid detergent
than the limit showed in the flap.
– Do not set the prewash phase.
– Do not set the delay start function.
You cannot set the delay start with the
Steam programme.
CANCEL THE DELAY START
1. Press button
4
flashes.
2. Press button
5
the display shows 0'.
3. Press button
4
starts.
• On the display all symbols related to the
load and to the quantity of detergent go
off.
electrolux 43
. The related indicator
again and again until
. The programme