At The End Of The Programme - Electrolux WA 1457 F Benutzerinformation

CHANGE A FUNCTION
You can change only some functions be-
fore they operate.
1. Press button
2. Change the function set.
SET THE DELAY START
1. Press button
the display shows the number of mi-
nutes or hours. The related symbols
comes on.
2. Press button
the countdown of the delay start.
When the countdown is completed, the
programme starts automatically.
Before you press button
appliance, you can cancel or change
the set of the delay start.
You cannot set the delay start with the
Steam programme.
CANCEL THE DELAY START
1. Press button
flashes.
2. Press button
the display shows 0'.

AT THE END OF THE PROGRAMME

• The appliance stops automatically.
• The acoustic signals operate.
• In the display
• The indicator of the Start/Pause button
4 goes off.
• The door lock symbol goes off.
• Press button
ance. After five minutes from the end of
the programme, the energy saving func-
tion automatically deactivates the appli-
ance.
When you activate the appliance again,
the display show the end of the last set
programme. Turn the programme knob
to set a new cycle.
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Keep the door ajar, to prevent mildew
and odours.
Downloaded from www.Manualslib.com
4
. The indicator flashes.
5
again and again until
4 , the appliance starts
4
to start the
4
. The related indicator
5
again and again until
comes on.
1
to deactivate the appli-
manuals search engine
3. Press button
4 . The programme
starts.
OPEN THE DOOR
While a programme or the delay start oper-
ates, the appliance door is locked.
To open the appliance door:
1. Press button
4 . The door lock sym-
bol in the display goes off.
2. Open the appliance door.
3. Close the appliance door and press
button 4 . The programme or the de-
lay start continues.
If the temperature and level of the wa-
ter in the drum are too high, the door
lock symbol stays on and you cannot
open the door. To open the door do
the steps that follow:
1. Deactivate the appliance.
2. Wait for some minutes.
3. Make sure that no water is in the
drum.
Important! If you deactivate the appliance,
it is necessary to set the programme again.
• Close the water tap.
The washing programme is completed,
but there is water in the drum:
– The drum turns regularly to prevent the
creases in the laundry.
– The door stays locked.
– You must drain the water to open the
door.
To drain the water:
1. If necessary, decrease the spin speed.
2. Press the Start/Pause button
appliance drain the water and spin.
3. When the programme is completed
and the door lock symbol goes off, you
can open the door
4. Deactivate the appliance.
The appliance drain and spin automati-
cally after approximately 18 hours.
electrolux 13
4 . The