Interrupting A Programme; Cancelling A Programme; Opening The Door After The Programme Has Started - Electrolux EWC 1350 Benutzerinformation

The programme can be changed as long
as the button Start Pause - Marche
Pause has not been pressed. Changing
a running programme is possible only by
resetting it. Turn the programme selector
dial to Aus - Arrêt and then to the new
programme position. Start the new
programme by pressing the button Start
Pause - Marche Pause again.

6.9 Interrupting a programme

Press the button Start Pause - Marche
Pause to interrupt a programme which is
running, the corresponding light starts to
flash. Press the button again to restart
the programme.

6.10 Cancelling a programme

Turn the selector dial to Aus - Arrêt
position to cancel a programme which is
running. Now you can select a new
programme.
6.11 Opening the door after the
programme has started
First set the machine to pause by
pressing the button Start Pause -
Marche Pause.
After some minutes, the door can be
opened, when the following conditions
are observed:
• The water temperature is below 55°C.
• The water level is below the bottom
edge of the door.
• The machine doesn't spin.
If you cannot open the door but it is
absolutely necessary to open it you have
to switch the machine off by turning the
selector dial to Aus - Arrêt. After few
minutes the door can be opened.(Pay
attention to the water level and
temperature!).
After this procedure, it will be necessary
to set the programme and the options
again and then press the button Start
Pause - Marche Pause.
6.12 At the end of the
programme
The machine stops automatically.
The pilot light D illuminates to indicate
that the programme has finished. The
pilot light E goes out, the door can be
opened and the laundry can be removed.
If at the end of a programme there is
water in the tub (when Spülstopp - Arrêt
Cuve Pleine option has been selected),
to empty out the water follow the
following instructions:
• turn the programme selector dial to
Aus - Arrêt
• select the Pumpen - Vidange or
Schleudern - Essorage programme
• press button Start Pause - Marche
Pause
When the pilot light E goes out, the door
can be opened and the laundry can be
removed.
At the end of the cycle, turn the
programme selector dial to Aus - Arrêt to
switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap.
Leave the door open to prevent the
formation of mildew and unpleasant
smells.
ENGLISH 11