Start The Programme; Altering An Option Or A Programme; At The End Of The Programme; Cancelling A Programme - Electrolux EWF1440 Gebrauchsanweisung

10. Start the programme

Press the START/PAUSE button. The relevant light
will stop flashing. The message relevant to the phase
that is in progress will be shown in the display.
If you have chosen a delayed start, the washing
machine will begin the countdown.
START/PAUSE

11. Altering an option or a programme

Before you make any change, you must pause the
washing machine by pressing the START/PAUSE
button.
It is possible to change any phase before the
programme carries it out.
When the programme has started, you can only
reset it by turning the programme selector dial to
STOP and then you can select the new programme.
The washing water remains in the tub. Start the new
programme by depressing the START/PAUSE
button.
Note: To drain the water before starting the new
cycle, you have to cancel the programme and select
the cycle.

12. Cancelling a programme

Turn the selector dial to STOP to cancel a
programme which is running.
Now you can select a new programme.
13. Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
START/PAUSE button.
If the door does not open, this means that the water
temperature is above 55°C, that the water level is
above the bottom edge of the door or that the drum
is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by turning the
programme selector dial to STOP. After about 3
minutes the door can be opened (pay attention to
the water level and temperature!).
Select the programme again and depress
START/PAUSE to restart it.
COTTON 08.30
Washing 12.00
40°C 1200
Exit
Temp. ° C T/Min. Options Change

14. At the end of the programme

At the end of the programme, the washing machine
stops automatically, gives an audible signal (if option
no sound has not been selected), and displays the
relevant message.
If the anti-crease
options have been selected, the START/PAUSE
button light is off.
The message "Door locked" appears in the display.
To drain or spin, first turn the programme selector
dial to STOP and then to drain programme
spin/delicate spin programme
Release of the lock is also indicated by the coming
on of the message "Door openable" (cycle ended).
Switch the machine off by turning the programme
selector dial to STOP.
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
99
(rinse hold) o r
(night cycle)
/ .
or