Water Drainage - Electrolux WASL2E 200 Benutzerinformation

and the movement of the appliance when
in operation.
• The appliance must be level and stable.
Caution! Do not put cardboard, wood
or equivalent materials below the
appliance feet to adjust the level.
THE INLET HOSE
• Connect the hose to the appliance. Turn
the inlet hose only left or right. Loose the
ring nut to set it in the correct position.
x4
45 45 45
O O O
20 20 20
O O O
• Connect the water inlet hose to the cold
water tap with 3/4 thread.
Caution! Make sure that there are no
leaks from the couplings.
Do not use an extension hose if the in-
let hose is too short. Contact the serv-
ice centre for the replacement of the in-
let hose.
Water-stop device
The inlet hose has a water stop device. This
device prevents water leaks in the hose be-
cause of its natural ageing. The red sector
in the window «A» shows this fault .
If this occur, close the water tap and con-
tact the service centre to replace the hose.

WATER DRAINAGE

There are different procedures to connect
the drain hose:
electrolux 53
A