Using The Accessories; Inserting The Accessories - JUNO JB096B9 Benutzerinformation

10
Setting the DURATION function
1. Set a heating function.
2. Press again and again until
starts to flash.
3. Press or
then the hours. Press
When the set Duration time ends the
signal sounds for 2 minutes.
setting flash in the display. The oven turns
off automatically.
4. Press any button or open the oven
door to stop the signal.
5. Turn the knob for the heating functions
to the off position.
Setting the END function
1. Set a heating function.
2. Press again and again until
starts to flash.
3. Press or
then the minutes. Press
At the set End time the signal sounds for 2
minutes. and time setting flash in the
display. The oven turns off automatically.
4. Press any button or open the oven
door to stop the signal.
5. Turn the knob for the heating functions
to the off position.
Setting the TIME DELAY
function
1. Set a heating function.
2. Press again and again until
starts to flash.
3. Press or
then the hours for DURATION time.
Press to confirm.
The display shows flashing

USING THE ACCESSORIES

WARNING! Refer to Safety
chapters.
to set the minutes and
to confirm.
and time
to set the hours and
to confirm.
to set the minutes and
.
4. Press or
then the minutes for END time. Press
to confirm. The display shows
and the set temperature.
Oven turns on automatically later on,
works for the set DURATION time and
stops at the set END time.
At the set END time the signal sounds for
2 minutes. and time setting flash in the
display. The oven turns off.
5. Press any button or open the oven
door to stop the signal.
6. Turn the knob for the heating functions
to the off position.
Setting the MINUTE MINDER
Minute minder can be both set when the
oven is turned on and off.
1. Press again and again until
starts to flash.
2. Press or
than the minutes.
When the time you set is longer than
60 minutes,
3. Set the hours.
4. The MINUTE MINDER starts
automatically after 5 seconds.
After 90% of the set time the signal
sounds.
5. When the set time ends the signal
sounds for 2 minutes. "00:00" and
flash in the display. Press any button
to stop the signal.
COUNT UP TIMER
To reset the Count Up Timer, press and
hold and . The timer starts to count
up again.

Inserting the accessories

Wire shelf:
to set the hours and
to set the seconds and
flash in the display.