Clock Functions - JUNO JH094C9 Benutzerinformation

10

CLOCK FUNCTIONS

Clock functions table
Clock function
TIME OF DAY
DURATION
END
TIME DELAY
MINUTE MIND‐
ER
Setting the time. Changing the
time
You must set the time before you operate
the oven.
The flashes when you connect the
appliance to the electrical supply, when
there was a power cut or when the timer is
not set.
Press the or
After approximately five seconds, the
flashing stops and the display shows the
time of day you set.
To change the time of day press
and again until
Setting the DURATION
1. Set an oven function and temperature.
2. Press again and again until
starts to flash.
3. Press or
time.
The display shows
4. When the time ends,
an acoustic signal sounds. The
appliance deactivates automatically.
5. Press any button to stop the acoustic
signal.
Application
To set, change or check the time of day.
To set how long the appliance operates.
To set when the appliance deactivates.
To combine DURATION and END function.
To set countdown time. This function has no effect on the op‐
eration of the appliance. You can set the MINUTE MINDER at
any time, also when the appliance is off.
to set the correct time.
again
starts to flash.
to set the DURATION
.
flashes and
6. Turn the knob for the oven functions
and the knob for the temperature to
the off position.
Setting the END
1. Set an oven function and temperature.
2. Press again and again until
starts to flash.
3. Press or
The display shows
4. When the time ends,
an acoustic signal sounds. The
appliance deactivates automatically.
5. Press any button to stop the signal.
6. Turn the knob for the oven functions
and the knob for the temperature to
the off position.
Setting the TIME DELAY
1. Set an oven function and temperature.
2. Press again and again until
starts to flash.
3. Press or
DURATION.
4. Press .
5. Press or
6. Press to confirm.
to set the time.
.
flashes and
to set the time for
to set the time for END.