JUNO JH094C9 Benutzerinformation Seite 27

What to do if...
Problem
The cooking zones do not
operate.
You cannot activate or oper‐
ate the oven. The display
shows "400" and an acoustic
signal sounds.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.
There is no good cooking
performance using the func‐
tion: True Fan Cooking
PLUS.
The water in the cavity em‐
bossment does not boil.
The water comes out of the
cavity embossment.
The display shows "12.00".
Possible cause
Refer to the operating instructions for the built-in cooking sur‐
face.
The oven is incorrectly con‐
nected to an electrical sup‐
ply.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The fuse is blown.
The lamp is defective.
You left the dish in the oven
for too long.
You did not turn on the func‐
tion: True Fan Cooking
PLUS.
The temperature is too low.
There is too much water in
the cavity embossment.
There was a power cut.
Remedy
Check if the oven is correct‐
ly connected to the electrical
supply (refer to the connec‐
tion diagram if available).
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Refer to "Activating the func‐
tion: True Fan Cooking
PLUS".
Set the temperature at least
to 110 °C.
Refer to "Hints and tips"
chapter.
Deactivate the oven and
make sure that the appli‐
ance is cold. Wipe the water
with a cloth or sponge. Add
the correct amount of water
to the cavity embossment.
Refer to the specific proce‐
dure.
Reset the clock.
27