Diagnose Tool" Interface; Delivery Scope; System Requirements; Install Software - Truma Diagnose Tool Gebrauchsanweisung

"Diagnose Tool" interface

Delivery scope

1 Diagnose Tool – interface / hardware
1 CD-ROM with software for
– "Error Explorer"
– "Live Display"
1 USB cable
2 cables – Combi connection (RJ12 – RJ12)
1 cable – Mover® connection (RJ12 socket – direct plug)
1 RJ12 coupling for cable extension
1 cable (with 5 mm jack on one side) – for the power supply
to the interface via the control unit

System requirements

Windows XP, VISTA, 7, 8 (not Windows RT)
Memory required on the hard drive: around 40 MB (if
Mic rosoft .NET Framework Version 4.0 is not installed, you
will require approximately 275 MB additional memory space
on the hard drive)

Install software

– Place the CD-ROM into the computer and then follow the
instructions on the screen.
Before the "Diagnose Tool" is connected, the software
needs to be installed on the computer.
Connect the "Diagnose Tool" to the computer
USB

Operating voltage

The interface requires a DC voltage of 12 V.
The power is supplied via
– the control unit,
– or via a cable connected to the control unit.

Update software

The current software can be downloaded in the dealer area
(see www.truma.com).
Each time it is started, the "Diagnose Tool" searches for
current software. If an error occurs (e.g. no internet
connection), a message is issued.
14

LED display

1
2
3
1 Error – red LED
– Gives the manufacturer
information about the data
traffic.
2 On – green LED
– Lit
USB connection and
operating voltage available.
– Flashes once (1 Hz)
operating voltage via
interface 1(2) missing.
– Flashes (1 Hz, 0.5 s off / on)
USB connection missing.
(connect / test cable)
3 Data – yellow LED
– Signalises the data transfer
on the bus.