Photonic PL 1000 Bedienungsanleitung Seite 5

Cleaning: Disconnect unit from the power supply before cleaning and only cle-
an with a damp cloth. Never use combustible or flammable liquids. If fluids acci-
dentally enter the device, unplug the power supply cable immediately and take
the unit to the service location.
Maintenance: The operator must maintain all national laws and standards for
regular inspections.
An inspection must be performed no later than every 2 years by specialists who
evaluate the safety of the device, recognize possible effects and dangers and
can determine the conformity with guidelines and standards. These inspections
should cover at least:
Protective conductor inspection, leakage current inspection, visual inspection
with cleaning and functional test
Spare parts: Only original spare parts may be used. If this is not done, it can
lead to personal injury and material damage. Refer to the "Spare Parts" section
for component codes.
Liability: As the ultimate legal entity, the operating institution is responsible
for ensuring the proper use of the device and for providing other operators with
the necessary information and it specifies the competencies required to operate
the device.
Disposal: Observe all national environmental requirements and laws for the
disposal of the device or its parts. Separate the components (e.g. by plastics,
electronics, lamps, metals...) and dispose of them through national disposal
companies!
Disconnect the power supply cable when the unit is not being used for an exten-
ded period of time. Use only original power cables and route the cables so that
they cannot be pinched or separated. For safety reasons, only use a 3-wire
power cable with protective conductor.
Repairs which are not described in this document must only be carried out by
authorized workshops!
The manufacturer is not liable for any damage resulting from a failure to comply
with the aforementioned instructions!
State of the art: This product constitutes state-of-the-art technology and
employs recognized safety standards.
This device was designed and built according to the following guidelines and
standards.
▼ 73/23/EEC: Low-Voltage Directive (CE)
▼ 89/336/EEC: Electromagnetic Compatibility (CE)
▼ EN 60598-1: Lamps
▼ EN 60601-1: Medical Electrical Equipment (for MED variants)
▼ UL 2601-1: Medical Electrical Equipment (for MED variants)